Friday, 27 February 2015

Reed float switch

Read the CynergyComponents Blog for insights, technical articles and help chhosing the right Float Switch , Flow Switch or RF and HV Reed Relay. Quickly choose the right Float Switch , Flow Switch or Reed Relay for your specific needs using the online help centre from CynergyComponents. How Magnetic Reed Liquid Level Sensors Work.


KV Hi-pot (dielectric breakdown) test. The internal magnetic reed switches are hermetically sealed to .

Magnetic Float sensors Vertical Normally open water Tank Alaram system - Duration: 3:05.

The single unit or multiple reed switch units are housed tightly in stainless steel or engineering plastic stem, and the permanent magnet is interlcircled into the middle of the specified float ball(s).

You can mount the float ball to penetrating through the stem, then the liquid buoyancy will deliver the float ball up and . The LLF Float Switches are designed for applications where very low levels of liquid need to be detected. The float will lift in as little as 6mm liquid and in SG as low as 0. View the full range of standard Float Switch , TAV ATEX Approved Float Switch , Flow Switch, and Reed Relay products manufactured by CynergyComponents. This Float Switch is fitted through the tank wall from the inside, via an Mthrea so requires access to the inside of the tank. While these switches are commonly used for tank level applications, they can fail and cause unreliability issues. A comprehensive range of multi-point switches using the reliable reed switch and magnet principle.


Bespoke manufacture to customer specification. Assemtech Compact Float Switch Horizontal Mounting. The liquid rises until the top float switch closes and energises the relay. Description of the float switch.


These measures are to avoid back EMF, induced over voltage transients, which can cause damage to the reedswitch contacts. The SSF2Float Switch range from Cynergyare horizontally mounted switches fitted from the outside of the tank. Get Datasheet and check stock here.


High level indication is at 24mm from the lower end of the . The movement of the float, due to the changing liquid level, will cause the reed . The FCNM Chamber Level Float Switch range from Cynergyis for use in liquids where SG is equal or greater than 1. When the magnetic field comes in close proximity to the reed switch, the float switch contact closes.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.