PS900-Summary, Legacy Supply ( PS8). If this limit is exceeded the fuse will blow in the power supply (Load is more than 2AMP at 24VDC or more than 4AMP at 12VDC). PS8power supply provides 2AMP at 24VDC or 4AMP at 12VDC.
The fuse may blow if wrong size fuse . During battery backup (873-BB required), output voltage rating is: 10.
For UL listed systems, all input and output devices must be UL Listed and compatible with the above ranges.
OF THE VON DUPRIN PS8POWER SUPPLY CAN BE USED TO POWER AND CONTROL ONE ACSI.
NOTE: THE VON DUPRIN 871- TWO ZONE CONTROLLER CARD MUST BE INSTALLED INSIDE THE PS873. Only the PS9series is UL2compliant. DISCLAIMER: INFORMATION PROVIDED THROUGH THIS SITE IS PROVIDED TO YOU AS IS WITHOUT ANY EXPRESS . The new VDboard mounts to the PS8in the same fashion as the factory original . Resolution: The following items may cause the PS9series power supply to have no DC output voltage. If the DC voltage selection jumper is missing, the power supply will not provide any D. Are the batteries for the PS 9BBK the same as the ones from the 8BB?
Resolution: This is not an option, the older RDS- was used with the older Falcon Monarch ELR devices. Hardwiring is always recommende but a plug-in line cord can be installed (by others) with the proper cor. Resolution: Use the PS902-2RS power supply with LCN auto operator on single door, PS904-2RS power supply on double door and . EL panics require 871- PCB minimum.
Turn off AC breaker and confirm there is no voltage on AC wiring. Label all field wiring and then disconnect. Ensure AC Breaker is Turned Off. Series option boards - 900-2RS, 900-4R, 900-4RL, 900-2Q.
Designed with hi-inrush for EL's). PS8-2Q power supply and the EPT- power transfer. Power Supply Cross Reference List.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.