Aquabot power supply problem

Replacement plug for the power cord. One screw opens it, screws hold the wire inside. Aquabot Motor Repair Requires . This video was created to send to the manufacturer to diagnose the problem.

Automatic pool cleaners aka robotic pool vacuums are popular inground and above ground pool accessory.

Quick and easy expert instructions to repair even the most complicated power supply failure , without the need for lea.

Never allow anyone to swim in the pool while the cleaner is in the pool!

Our knowledge base provides valuable online support for your robotic pool cleaner including videos, troubleshooting information, and user manuals. WARNING: The Power Supply must be at . There seems to be some undiagnosed problem with either the power supply or the pump motor. PRODUCT SETTINGS and TROUBLESHOOTING. Midpoint of the Long side of Pool.

Setting up the power supply is simple. Then lift the cover on the power supply outlet and connect plug on the floating cable into. QUICK START INSTRUCTIONS (Steps 1-5). Straighten out the floating cable.

DO NOT RETURN ClEANER TO RETAIlER! For more information on robot repair and our service center visit dolphinpoolsupply. Leave all questions and comments in the comments section. The Pool Rover Jr works off of an external power supply and does not need to be connected to your pool to work.

Before performing any troubleshooting maintenance procedures, your Cleaner should be disconnected from the Power Supply (transformer) and the Power Supply should be unplugged from the electrical outlet to prevent the possibility of personal injury or damage to your Cleaner! Check power to the socket and reconnect Pool Cleaner Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box. By changing the axle set-up using the slider on the front of the cleaner, you can adjust how tight or wide the cleaner turns. There could be an issue with power supply , or the pump motor.

To test the power supply , plug the power supply into your wall outlet, without the robotic cable plugged into it. Make sure the filter bag is clean. Sorry for sound loss nothing cruci.

Before performing any troubleshooting or maintenance procedures on your cleaner, it should be disconnected from the Power Supply (transformer) and the Power Supply should be unplugged from the electrical outlet to prevent the possibility of personal injury or damage to the cleaner. Check that the power supply cable is plugged properly into the power supply socket. Always Unplug your Power Supply .