The GH - 3sensor works by transmitting an ultrasonic (well above human hearing range) burst and providing an output pulse that corresponds to the time required for the burst echo to return to the . The LINX toolkit provides VIs for ultrasonic sensors that work with all LINX devices including myRIO, chipKIT and Arduino. Can the GH - 311RT measure distance as well? I bought these sensors and thought that the output was analog according to distance.
Working Voltage : 5V(DC) , Static current: Less than 2mA.
Output signal : Electric frequency signal, high level 5V, low level 0V.
Detection distance : 2cm-450cm.
Sensor angle : Not more than degrees. LINX Resource Contains LINX connection resources. Trig Specifies the LINX device digital output channel connected to the HC-SRTrig pin. Echo Pin (DI) Specifies the LINX device digital input channel connected to the HC-SREcho pin.
Error In Describes error conditions that occur before this node runs. SIG Pin (DIO) Specifies the LINX device digital input channel connected to the PING))) SIG pin. This input provides standard error in functionality. Working frequency : 40HZ Output Signal : 0- 5V (Output high when obstacle in range) Sentry Angle : max degree. Input trigger signal : 10us TTL . Compared to the Shap IR ranging module , HC-SRis more inexpensive than it.
For forward distance measurement the sensor used is GH - 3and for blind spot detection the sensor module implied is HC - SR04. The measuring range of HC- SRis 2cm - 4m. The GH - 3ultrasonic Motion sensor provides precise, non-contact distance measurements from about 0. SRF0 SRFultrasonic ranging module and abroad comparable. Module precision, blind spots (2cm) super close, stable ranging success of this product according to market powerful!
Vehicle approach sensing system. It outputs distance very accurately in centimeters (cm). Seven Segment Display Module(Digit).
No comments:
Post a Comment
Note: only a member of this blog may post a comment.