An autotransformer is an electrical transformer with only one winding. The auto ( Greek for self) prefix refers to the single coil acting alone and not to any kind of automatic mechanism. In an autotransformer , portions of the same winding act as both the primary and secondary sides of the transformer.
It is used to transfer electrical energy, and to increase or decrease the tension in an AC circuit , keeping the frequency. The autotransformer has only one winding.
DXF, DWG and Visio formats available.
Non short-circuit-proof autotransformer.
Short-circuit- proof autotransformer. Safety transformer for supplying premises containing electro- medical equipment. Reactor without overload protection. There are several differences between the autotransformer and the conventional transformer.
One of the major difference between them is that the autotransformer has only one winding whereas the conventional transformer has two separate windings. The other differences between them are explained below in the form of . Phase auto transformer symbol : 4. Motor starter symbol, Motor starter. Generic symbol, Starter with automatic disconnection symbol, Starter with automatic disconnection. Regulator starter symbol, Regulator starter, Starter motor trigger symbol, Starter motor trigger. Starter autotransformer symbol , Starter autotransformer, Starter regulator thyristor symbol . Power can be transferred between the two coils through the . The symbols in this appendix are from IEEE Std 3and IEEE Std 315A.
These symbols are commonly used on electrical diagrams reviewed by loss control personnel. This appendix lists the symbols in the following groupings: Switches, Contacts, Rotating Machinery,. Transformers , Connections and Miscellaneous.
An air-core transformer symbol is shown with out vertical lines between the windings. The common point may also be located . A transformer with only one winding. One can also make an autotransformer from an ordinary transformer by cross-wiring the primary and secondary windings. This motor starting method has been updated and improved by Hilton Raymond Bacon . Designation of connections of three-phase auto - transformers by connection symbols. INTERNATIONAL ELECTROTECHNICAL COMMISSION.
Autotransformers do not provide galvanic isolation. They have electroconductive connection between input and output winding.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.