Friday, 3 April 2015

Integra clutch interlock switch

Switch was goo but the plastic stop that presses the sw. If you go to start you car and the lights come on, but you get dead silence when you turn the key ir may be your Clutch pedalstoppers have fallen out. The lower will effect your cruise control and your rear lights will stay on even with the key out of the ignition.


Acura Integra lights but silent no start. Additional note: Make sure the clutch pedal bracket is tight to the firewall, cross member, or whatever framework it attaches to.

Yeah, same thing happened to me ( with the clutch pedal interlock stopper thingy).

I was getting some parts for another car and had to bump start the car to get home.

The pedal pad stopper for clutch switch B (cruise control) was easy to replace. Ran out of memory at the end but all important and helpful information was covered. Clutch pedal assembly is removed for better visual inspection for greater underst. Clutch Interlock Switch Troubleshooting - Duration: 2:40.


The clutch pedal safety switch on the Accord sends an electrical signal to the Electronic. My clutch interlock switch went out about 75K miles ago. I just pulled the connector from the switch and jumped the connector and taped it up.


We know our parts and products. This video will cover variety of issues that pertain to no starting issues. Like battery, terminals, main relay, starter cut off switch , clutch interlock swi. To adjust Pedal Freeplay, loosen the locknut on the clutch pushrod.


Then back off the pushrod to adjust pedal freeplay to specified range. Please feel free to PM me with any questions or comments. You can find this wire in its own split loom by tracing it . Adjust the position of the clutch interlock switch so that the engine will start with the clutch pedal in this position. Honda civic si clutch pedal assembly. Bypassed my CSS car turned over.


I was driving home today and felt something hit my left foot. Found out my plastic stopper on the brake pedal broke off causing my brake lights to remain on (which was the thing that hit my foot). Is the battery ground wire loose or corroded?


No, it works in conjunction with the clutch interlock switch. There are two pedal stoppers for my Accord: an easy-to-reach lower stopper for the clutch switch that works with the cruise control, and an upper stopper for the clutch interlock switch that prevents the car from being started in gear by making sure that the clutch is depressed before sending power to . Depressing the clutch pedal disengages the. Loosen the locknut on that switch. The switch is designed to prevent the vehicle from starting when the clutch pedal is not being pressed to prevent any sort of unintentional starting of the engine with the transmission in .

No comments:

Post a Comment

Note: only a member of this blog may post a comment.