Stiffening Lips on Cee Sections. The final element agreed upon was the dimension of the stiff- ening lip by flange width and material thickness. Mils KSI thickness thickness code. Gauge depths widths range range.
Thickness: mils (20ga), mils (18ga), mils (16ga), mils (14ga) and mils (12ga).
Standard coating: CP(Gavailable) .
AISI “ Specification for the Design of Cold Formed Steel Structural Members”.
Two common references for architects to select metal framing for interior partitions and ceilings perpetuate the use of gage. Metal Framing Thickness or Gage. Metric (mm) minimum thicknesses were calculated by converting the Imperial (in.) values.
Ro: Polar radius of gyration about the centroidal principal axis. Lu: The longest weak axis (Ly) and torsional (Lt) unbraced length at which lateral torsional buckling is restrained in accordance with AISI C3. ASTM A6Grade (steel) and ASTM A9(coating). These studs and track are manufactured from mill certified galvanized steel, and are designed for use in curtain-wall and load bearing applications.
Thicknesses range from mils (gauge.) to mils (gauge.). Architect or Engineer of Record. Product Information for SSCJ (Joists) and SSRT ( Rim Track).
Custom sizes, lengths and coatings available. The place to stop…before the building starts! Slip track for track- over-track assemblies is also available. You can depend on strong traditional gauge MRISMART studs because true strength is measured in mils.
Sheet steel thickness is measured at any point no less than Vin. New DOT regulations that went into effect for new packaging manufacturers on Oct. Track is normally ordered in corresponding size and gauge to the wall studs.
GAUGE ) AND LIGHTER: KSI MIN. MISCELLANEOUS STEEL TO CONFORM TO THE FOLLOWING: A. Stud Thickness, Yield Strength (ksi), Allowable Loads (lbs).
No comments:
Post a Comment
Note: only a member of this blog may post a comment.