How to get 480 volts

The 4volts is usually for motors and some appliances and the 2volts is used for lighting. A transformer is needed in these systems to obtain 1volts for receptacles. Rotary phase converters use an electric motor with . This system serves hotels, shopping centers, etc.

Transformers are used to get 120- volt single-phase circuits.

Question We are setting up our new shop and the current coming into the building is 4volts.

I have wired all my buildings before with 3 .

Also, conductors operating at higher voltage have lower losses. Power lines operate at extremely high voltage, sometimes in the hundreds of thousands of volts. Doing so has two advantages: The current is greatly reduce so you can . A large textile plant purchased several looms from Europe, which operate on 380V, 3-phase.

The only distribution voltage available is 480V , 3-phase. The plant requested advice on the most economical way to obtain 380V for these loads. He went to take copper and pulled the meter. CT and when you pull the meter it does not kill the voltage. He got into 4volts the service . I would experiment with the windings by cutting the wires on the armature and rewiring it, so you may end up with more poles as you have to remove the centre tap, the motor may be slower but should work?

When checking the volts of each wire to groun I get 150V, 550V and 350V. This can include electric motors running at 4Volt , appliances and production equipment using 2Volt , and smaller loads and power tools at 2Volt. My 4volt switchgear has no available space for another disconnect, however the . KVA based on the required load voltage, line voltage and load current.

Article 2of the National Electrical Code addresses 277- and 4- volt branch circuits. Also regarding the two hot 120VAC lines that come into . Which might explain why you see 240V between the neutral and phases. Please recheck voltage again to make sure that this is the case.

In other case you should have either 277V line voltage or 415V phase . Typical markings on strait-rated breakers would be 2volts , 4volts , or 6volts. Corner-grounded systems usually require strait-rated breakers to be installed in the system. Based on the wiring to the equipment you get different phases which change the amount of power that can be consumed.

If you want to know more about phases go here: Three-phase electric . Enclosure Type - NEMA 3R (Outdoor). The phase you measured zero volts on is actually the grounded conductor where it is tied to everything metal in the structure.