Pir sensor light instructions

During the hours of darkness the unit fully illuminates when it senses movement within its detection field. An integral daylight sensor ensures night-only operation if required. Please keep safe for future reference.

The ZV8can be installed at various heights from 0. Plastic Wall Plug (not included).

Make sure the wiring connection is correct.

If you set the motion sensor to Manual Override, remember that you must turn the wall .

ALWAYS switch OFF the mains power BEFORE attempting to install or maintain the 2PIR. Terminal or Electricians screwdriver. Disassemble the PIR main body and insert the battery into the contact sensor.

IPRated suitable for restricted internal applications. Light pollution caused by incorrectly. These instructions should be read carefully and retained for further reference and maintenance. Before installation or maintenance, ensure the mains supply to the. PIR sensor is switched off and the circuit supply fuses are removed or the circuit breaker turned off.

Using the power of the sun, light any dark area and add extra security with the Sunforce Solar Motion LED Security Light. I have the same light but 1LED. This light automatically turns o. In dark conditions the manual override disables the PIR allowing the lights to be turned off indefinitely or when the override switch is re-pressed.

When locating the position of the unit avoid . At night, the built-in passive infrared ( PIR ) motion sensor turns on the floodlight when it detects motion in its coverage area. Note : Read this entire manual before you start . Lighting loads connected must not exceed . Lamp stays ON all the time at night. The PIR sensor will not operate at night. All slave units are designed to control lighting , heating and ventilation. Welcome to use STinfrared motion sensor!

The product adopts good sensitivity detector and integrated circuit. It gathers automatism, convenience. Can identify day and night: The consumer can adjust working state in different ambient light. It can work in the daytime and at night . MicroWave sensors are significantly more sensitive that. The unit has been working fine up until now and the wi.

Passive Infra Red ( PIR ) sensors , which only detect changes in heat against the. By Default the Sensor is set to dim the product to light. Do not mount this product on flammable or conductive surfaces.

Ensure the power supply is switched off before fitting or servicing.