Thursday, 8 December 2016

Power supply test paperclip

If your unit is not giving any signs of powering on you can test it using the Paperclip test. You will need: 1x metal paperclip. Disconnect your power supply from your motherboard if you have not already.


Flip the switch on the back of your power supply to the off position 0. All you are doing here is jumping the PS-ON signal cable to ground which allows the PSU to power on.

A bad PSU may seem fine when it is under no load as it is here, the fan spins, and you may even be .

By bridging the connection between the green wire and the black wire you are completing the circuit and powering on the power supply.

When you turn it on after putting the paperclip into your 24-pin, if the fan spins, then your . This paperclip will act as the pins that are inserted into the power supply that give it . How to Jump Start your power supply ( Paper clip test ). Unplug the AC power cord from the power supply. Unplug all hardware devices cable from the power supply. The excess heat generated by the PSU will add to the overall temperature of the system unit.


If this failure is not correcte the PSU will become damage. A damaged PSU can, potentially, damage the components as well . The start button is doing nothing, no fans spinning, no noises, no nothing. If the power supply does not turn on, then you can be 1 certain that it is dead. If it turns on, you are probably fine.


Want to know if your power supply is working? Autoplay When autoplay is enable a suggested video will automatically play next. The whole thing behind the paperclip trick is to allow you to turn on your power supply ( PSU ) without plugging it into the motherboard and pushing the power button in front of your computer. This is too inconvenient for people who wants to use their power supply to test out certain things, and to get around . The first things we need to identify are the main power connectors that run from the PSU and attach to the motherboard to supply the voltage and current that your motherboard and its components need. I thought it was the PSU because he said before it became completely dea it turn on and then suddenly turned off.


I disconnected all the cables from the motherboard to test the PSU. On the Pin connector locate the . I did the paper clip test on my PSU ( OCZ ZX 850W). The first method we are going to look at is the ' paper clip test '. The PSU clicked once, fan did not turn on.


Using the Cuda-Z app, the rig keeps running when heavy load test mode is checked.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.